DECARBONISING DISTRICT HEATING: DIFFERENT STARTING POINTS, SHARED LESSONS

Decarbonising district heating takes more than replacing fossil fuels with renewable heat. Findings from ten SupportDHC cases across six European countries show there is no single recipe, but a common approach could be suggested. Further, unlocking local renewable sources and waste heat often requires heat pumps, thermal storage and lower network temperatures with complementary technologies tailored to each system, rather than a single solution.

By Prof. Paola Caputo, PhD, Associate Professor of Building Physics at Politecnico di Milano

Published in Hot Cool, edition no. 6/2026 | ISSN 0904 9681 |

Introduction

District heating and cooling (DHC) operators across Europe are facing a common long-term challenge: transforming existing systems towards climate neutrality while preserving security of supply, economic viability, and affordable heat for customers. Nevertheless, the experience gained in the project “SupportDHC” shows that this transition takes place under highly heterogeneous technical, regulatory, and market conditions.

The project has worked with ten frontrunner cases covering six countries and includes systems that differ substantially in size, generation mix, network temperatures, market organisation and stage of decarbonisation. Accordingly, the support provided within the project has been tailored to the specific needs and transformation status of each operator. 

The EU Life project SupportDHC helps DHC operators develop realistic transformation pathways to integrate low-grade heat into existing systems and combines case-based technical support, planning methods, and practical tools to help move from decarbonisation targets to implementation.

The main results of the project are reported on the website (https://www.euroheat.org/dhc/eu-projects/supportdhc), where several public deliverables are available, together with the replication hub that includes tools and guidelines for all the actors involved in DHC.

A distinctive feature of SupportDHC is its focus on accelerating the integration of low-grade renewable energy sources (RES) and waste heat (WH) into DHC systems. Low-grade resources mean low-temperature heat and typically include ambient heat, wastewater and sewer heat, river or groundwater heat, and low-temperature industrial and data-center waste heat.

Since the temperature is below that required for direct supply to conventional high-temperature networks, heat pumps are required. However, existing and future portfolios also include higher-grade renewable or recovered heat, such as biomass, waste-to-energy, some industrial waste-heat streams, solar collectors and, depending on local conditions, deep geothermal energy.

The SupportDHC frontrunners illustrate how widely the starting points for decarbonisation can vary, highlighting the importance of adopting a diversified portfolio of complementary technologies rather than relying on a single solution.

In Kapfenberg, Austria, the main network remains strongly dependent on natural gas, which supplies around 80% of heat, while industrial WH already contributes to the system and represents one of the main opportunities for further decarbonisation. The transformation strategy therefore combines greater exploitation of industrial heat, biomass, and storage integration, as well as renewable electricity, with a gradual reduction in gas use.

In Alytus, Lithuania, the situation is markedly different since approximately 97–98% of heat generation is already based on renewable sources, mainly biomass. The challenge is consequently not the initial substitution of fossil fuels, but increasing flexibility, efficiency, and competitiveness of an already highly renewable system, e.g., reducing gas use during peak periods and improving the operation of biomass CHP.

The case of Neveronys, again in Lithuania, demonstrates that very different situations may coexist within the same national context: while the wider Kaunas system has a high share of biomass and municipal waste, the small Neveronys network remains entirely gas-fired and requires a deep transformation of its generation portfolio, including HPs and thermal storage.

In Italy, the three frontrunner systems also represent different challenges. Lodi is examining the feasibility of integrating low-temperature heat from a municipal wastewater treatment plant through large-scale heat pumps, in a context where industrial WH opportunities are relatively limited. Cremona, by contrast, already combines biomass and heat recovery from waste-to-energy and therefore faces the challenge of integrating additional decarbonised heat without creating competition among existing baseload sources; thermal storage becomes particularly important in this context.

Reggio Emilia represents a large, high-temperature system still largely based on natural-gas CHP and boilers, with supply temperatures around 120°C, and thus provides a relevant example of the challenges and possible solutions involved in introducing low-grade RES and WH into mature conventional networks. This case exemplified how to increase the share of WH and RES and progress toward meeting the EED criteria across the forecasted milestones.

In Germany, Frankfurt is pursuing a broad transformation strategy based on a diversified future supply portfolio that includes data-centre and industrial WH, wastewater and environmental heat with heat pumps, geothermal energy, waste-to-energy, biomass and power-to-heat. The case clearly illustrates the coexistence of low-grade sources requiring temperature upgrading and higher-grade resources that can be integrated more directly into the network.

The two Polish cases start with systems in which coal phase-out remains a central concern. In Skarżysko-Kamienna, four coal boilers need to be replaced, and the operator is simultaneously examining biomass combustion combined with flue-gas condensation and absorption heat pumps, while addressing the very high temperatures required by part of the network.

In Chojnice, the analysis combines biomass utilisation with the recovery of low-grade heat from flue-gas condensation and an air-water heat pump, showing how low-grade recovery technologies can improve the efficiency and resource use of a higher-grade renewable heat source.

Finally, Lviv, located in Ukraine, faces a particularly complex transformation context, characterised by full reliance on natural gas, substantial network and end-use losses and, in addition, war-related risks to energy infrastructure and continuity of supply. The potential portfolio includes both low-grade resources, such as wastewater heat, and higher-temperature options such as deep geothermal, together with broader infrastructure modernisation needs.

Taken together, these examples show that there is no single starting point and therefore no single decarbonisation pathway. The same long-term policy objectives translate into very different priorities depending on the existing fuel mix, network configuration, local heat-resource availability and maturity of previous investments.

Methodological approach for the frontrunner support cases

The activities with the ten SupportDHC frontrunner cases were developed through a structured, operator-oriented methodological process combining formal cooperation, primary data collection, technical assessment, and iterative validation.

For each case, a collaboration agreement was established with the DHC operator, defining the scope of the support activities, the respective roles of the partners, and the information required for the analysis. This provided a common framework for accessing and exchanging operator-specific technical, operational and, where relevant, economic data.

The analytical process started with reconstructing and validating the current system baseline, including heat demand, generation assets and energy mix, network characteristics and operating temperatures, existing renewable and waste heat contributions, and relevant local boundary conditions.

Depending on the specific needs and maturity of each frontrunner, the analysis was then extended to the identification and characterisation of potential renewable energy and waste heat sources, the assessment of enabling technologies, and developing alternative system configurations and transformation scenarios.

The project deliberately adopted a common methodological logic but case-specific analytical depth, reflecting the very different starting conditions and decarbonisation challenges of the ten operators. This aligns with the SupportDHC approach, in which support ranged from assessing individual measures to developing broader transformation strategies.

Where appropriate, quantitative modelling and techno-economic assessment were used to compare alternative pathways under consistent boundary conditions, considering parameters such as energy demand, resource availability, temperature levels, energy prices, investment requirements and operational constraints. Results and assumptions were progressively discussed with the operators and documented.

The resulting outputs therefore represent decision-support evidence grounded in real operating systems. This co-development process also increases the robustness and practical relevance of the results, while facilitating their subsequent transfer to follower and replicator cases.

Results

The analysis of the ten SupportDHC frontrunner cases highlights substantial differences in regulatory conditions, network characteristics, market structures and decarbonisation maturity.

A first cross-cutting result concerns the uneven interaction between European requirements and national and sub-national regulatory frameworks. Article 26 of the revised Energy Efficiency Directive (EED) introduces progressively stricter criteria for efficient DHC systems, but transposition, practical implementation and application have advanced at different speeds across the SupportDHC countries and, in some cases, across regions (or Länder).

Operators therefore face different levels of regulatory certainty when planning long-lived investments. National and regional differences also concern the treatment of specific heat sources and technologies, while taxes, subsidies, electricity and fuel prices, and market design influence the competitiveness of alternative decarbonisation options.

This points to the need for more coherent transposition, clearer implementation and application rules, and sufficiently stable framework conditions, so that operators can anticipate future compliance requirements and translate them into credible long-term transformation and investment pathways.

To support this process, SupportDHC developed a preliminary EED Article 26 compliance tool, available through the Replication Hub. The tool allows operators to screen alternative future system configurations against successive regulatory milestones and to identify potential compliance gaps early enough to inform transformation and investment planning.

A second result relates to network temperature levels, which strongly affect the integration potential of low-grade heat. The frontrunner cases show a wide range of operating conditions: Alytus and Neveronys, Lithuania, operate around 75/45°C and 73/43°C respectively, while Reggio Emilia, Italy, operates mainly around 120/70°C.

In Skarżysko-Kamienna, Poland, winter supply temperatures reach 130 °C and specific industrial demand further constrains temperature reduction. These cases confirm that the feasibility of low-grade heat integration depends not only on source availability, but also on network and end-user requirements. High temperatures increase heat losses and reduce heat-pump efficiency, so decreasing them could improve the global economic feasibility.

Economic viability emerges as a third major result. Low-grade renewable and waste heat sources can be locally available at low marginal cost, but exploiting them may require significant investments in heat pumps, heat exchangers, storage, electrical connections and network adaptation. Their competitiveness therefore depends on the interaction between CAPEX, electricity prices, operating hours, heat demand and the cost of displaced generation.

Conclusions

The SupportDHC results indicate that transforming DHC systems should be approached as a system-level process. Low-grade renewable energy and waste heat can unlock local resources, including wastewater, data-centre heat, environmental heat and low-temperature industrial streams, but their integration often requires complementary measures such as heat pumps, thermal storage, electricity-grid capacity, and more sophisticated and digitalised control systems.

The diversity of the frontrunner cases is a key strength of SupportDHC because it allows common barriers and enabling conditions to be identified across very different technical and market contexts. The findings point to four main priorities for accelerating DHC transformation: stable and predictable regulatory frameworks, removal of market distortions, integrated planning of generation, networks and end uses, and economic conditions capable of mobilising investment while maintaining sustainable customer tariffs.

These elements are also important for replication, as they show that technical solutions need to be adapted to local system conditions and embedded in appropriate regulatory, market and contractual frameworks.

Disclaimer

The SupportDHC project (contract no. 101119914) is co-funded by the LIFE Programme of the European Union. Views and opinions expressed are, however, those of the author(s) only and do not necessarily reflect those of the European Union or CINEA. Neither the European Union nor the granting authority can be held responsible for them.

Prof. Paola Caputo, PhD

Paola Caputo is an Associate Professor of Building Physics at Politecnico di Milano, with a PhD in Energy Engineering and a degree in Environmental Engineering. Her research combines energy modelling and environmental assessment to advance energy efficiency, renewable energy integration and decarbonisation, from buildings to regions. She brings extensive European and national project experience in district heating and cooling, energy planning, stakeholder engagement and skills development.

1. What makes this subject exciting to you?

As an academic, I find most rewarding working at the interface between research, institutions, and companies. I like research that goes beyond analysis and contributes to concrete decisions, practical tools, and tangible results. District heating and cooling is particularly stimulating in this respect because its transformation is highly systemic: technical solutions are often available, while the real challenges lie in coordination, regulation, investment conditions, data availability and the capacity of different actors to work together. This is also why I have devoted significant attention to capacity building, which I see as a key part of making the transition actually happen.

2. What will your findings do for DH?

I hope that our findings will help reduce the gap between decarbonisation targets and implementation. We understood that many barriers are not primarily technical, but linked to regulatory uncertainty, uneven implementation of European and national frameworks, fragmented responsibilities, different market conditions and limited access to knowledge and skills. By combining case-based analysis, practical tools and capacity-building activities, we aim to support operators and public authorities in navigating these differences and in translating long-term objectives into realistic transformation pathways.

1. SupportDHC webpage: www.supportdhc.eu
2. SupportDHC Replication Hub: www.replicationhub.supportdhc.eu

For further information, contact paola.caputo@polimi.it

“Decarbonising District Heating: Different Starting Points, Shared Lessons” was published in Hot Cool, edition no. 6/2026. You can download the article here:

Did you find this article useful?

Subscribe to the HOT|COOL newsletters for free and get insightful articles on a variety of topics delivered to your inbox twice a month!

Related posts

REBUILD WHAT EXISTED – OR BUILD WHAT NEVER EXISTED?

EUROPEAN ENERGY RESILIENCE STARTS WITH BETTER ENERGY USE

CONSUMER PROTECTION STARTS BEFORE THE HEAT BILL